>NAME >VALUE PCB EDGE >NAME >VALUE Bluetooth 4.2 BLE Module Shielded Antenna ASCII Interface 9x11.5mm <b>RESISTOR</b> >NAME >VALUE <b>RESISTOR</b><p> wave soldering >NAME >VALUE >NAME >VALUE <b>CAPACITOR</b> >NAME >VALUE >NAME >VALUE <b>SOT 23</b> >NAME >VALUE >NAME LED 1206 pads (standard pattern) >NAME >VALUE LED1206 FAB style (smaller pads to allow trace between) >NAME >VALUE 5mm round through hole part. >NAME >VALUE <b>CAPACITOR</b> >NAME >VALUE >NAME >VALUE >NAME >VALUE (Black) (Green) LED >NAME >VALUE non-polarized capacitor >NAME >VALUE <b>Resistor (US Symbol)</b> <p> Variants with postfix FAB are widened to allow the routing of internal traces LED <b>Supply Symbols</b><p> GND, VCC, 0V, +5V, -5V, etc.<p> Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals.<p> The pin name defined in the symbol is identical to the net which is to be wired automatically.<p> In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic.<p> <author>Created by librarian@cadsoft.de</author> >VALUE <b>SUPPLY SYMBOL</b> Since Version 8.2, EAGLE supports online libraries. The ids of those online libraries will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports URNs for individual library assets (packages, symbols, and devices). The URNs of those assets will not be understood (or retained) with this version.